Robertshaw11-293 1/4" Tubing with Fittings, 5" Roll, Aluminum

These are great replacement kits at an excellent price. HVAC wholesale houses sell these things for $30 a pop or more (if they have any in stock). These tube kits will work for almost any pilot application in a wall furnace, floor furnace or old forced air furnace.Keep in mind that if you don't get the nuts and ferrules on correctly you will create a gas leak.... which can be very dangerous when you have it next to a lit pilot. If you aren't sure, call a professional to avoid burning your house down!

Ken N.s review is spot on in regards to different fittings used for your application. There is a break away style and a regular loose ferrule and nut. You have to determine what is correct. As you can figure, the nut(s) have to be slid on first, then insert the cut end of the tubing fully through to the pilot burner or solenoid valve (make sure orifice is seated all the way to the pilot burner first )- You will find that the aluminum tubing will merge into the pilot orifice about a 1/4 inch. then you have one chance to thread the nut into the pilot then tighten snugly and a bit more because you are compressing the ferrule and permanently keeping that ferrule location crimped on the tubing. So if you try to remove the nut, the ferrule is not moving from the crimped location. Take your time and do not bend the tube sharply or it will kink. Use a tubing cutter to cut this product and clean any burrs off. many new pilot assemblies require you to use and form new tubing because the old burner ferrule locations may not apply to the new pilot or valve.If you are unsure, consult a professional- Good Luck and potentially save you some money!

Good. Its what i need.

I used this to replace the pilot tube in my Lennox furnace. It came with two compression fittings, although slightly different types (likely to accomodate different uses). I needed one for each end. One goes in the gas module and the other in the pilot orifice. One is a single fitting piece with a breakaway ferule. The second is a screw fitting, separate ferule, and nut. I was able to the fix the separate ferule on the tube by tighting the nut on and then removing it. Installed and I'm all set. My pilot flame looks better than ever, and the furnace lit up in no time. The tube is a bit longer than my original, but I was able to find space to fit it all inside. Great product!

Used to replace pilot tube for a SW12DEL worked like a champ. Came with a one of the the fittings I needed and I reused one of the ones on there.